Read These Notes First; Charger Pod; Base Unit; Mains Power Connection - Binatone E3300 Manual

Contents
Customising your base unit
The base unit's PIN code 27
Emergency numbers 27
Ringer volume and melody 28
Call barring 28
Date and time 30
To clear all Caller Display
memories 31
To reset the base unit 31
Indirect Network
To set the network access code 32
To set additional 'local' dialling
codes 33
To turn Indirect Network on and
off 33
Troubleshooting
Cleaning and care
Declaration of conformity
Connection and conditions for use
You can connect your e3300 to a direct exchange line (DEL) - a line
connected to a local exchange, with its own phone number; to an
extension socket connected to a DEL; or to an extension on an
approved compatible PBX. Do not connect the e3300 as an extension
to a payphone.
The ringer equivalence numbers (RENs) of all instruments (phones,
fax machines, etc.) connected to an exchange line must not add up to
more than 4 - otherwise, one or more of them may not ring and/or
answer calls correctly. The e3300 has a REN of 1, and most other
telephones have a REN of 1 unless marked otherwise.
2
27 Guarantee and service
While the unit is under
Guarantee 41
After the Guarantee has expired 41
Technical details
Index
32
34
40
40
41
Choosing a
site for the
base unit and

charger pod

42
43
Radio signals
between
handset and

base unit

Mains power
connection
Binatone Help Line: 01325 304 473

Read these notes first

The base unit and charger pod should each be placed
on a level surface, in a position where:
I
the mains adapter plug will reach an easily accessible
230-V switched mains supply socket - never try
AC
to lengthen the mains power cable
I
the base unit's telephone cable will reach your tele-
phone line socket or extension socket (the charger
pod does not have a telephone line connection)
I
it is not close to another telephone - this can cause
radio interference
I
it is not close to a sink, bath or shower, or anywhere
else where it might get wet
I
it is not close to other electrical equipment - fridges,
washing machines, microwave ovens, fluorescent
lights, TVs etc.
To use your handset and base unit together, you must
be able to establish a radio link between them. Be
aware that:
I
Any large metal object - like a refrigerator, a mirror
or a filing cabinet - between the handset and the
base unit may block the radio signal.
I
Other solid structures, like walls, may reduce the
signal strength.
IMPORTANT -
I
The e3300 base unit must be used with mains
adapter, part no. XX002136D, supplied with the
unit.
I
The e3300 charger pod must be used with mains
adapter, part no. XX002137D, supplied with the unit.
Using any other adapter will result in non-compliance
with EN60950, and will invalidate any approval given to
this apparatus.
3