Binatone E3300 Manual page 21

Troubleshooting
"There is inter- Move the handset closer to the base unit, or to a
ference and different position.
noise on the
Try moving the base unit so that it's not near other
line."
electrical equipment, such as a television or a
computer.
You'll get the best results if you site the base unit as
high as possible. For example, in a two-storey house,
the first-floor landing is an ideal place for the base unit.
"I hear 'beeps' You may be going out of range of the base unit. Move
from my closer, or your call may be cut off.
handset while
Check the Battery Level symbol on the display. If it is
I'm on a call."
low, recharge the batteries.
"The Caller You need to subscribe to the Caller Display feature from
Display feature BT or your service provider.
isn't working."
The caller may have withheld their number by dialling
141. Or they may be calling from a network that does
not transmit the Caller ID (for example, it may be an
international call).
"When I try to If you're using a e3300 Twin system, or have extra
make a call, I handsets registered to your base unit, check that
hear Busy another handset isn't already in use on a call.
tone."
"The volume in Make sure you're holding the earpiece correctly over
the earpiece is your ear.
low when I'm
Adjust the volume using the
on a call."
36
L M
or button.
Using a multi-handset system
"I can't transfer Make sure the other handset is within range of the base
unit.
a call."
Make sure you're dialling the correct number for the
other handset (1 to 6, or 9 for all registered handsets).
Customising the handset and base unit
"When I try to Have you set a PIN code for your handset and/or base
change the unit? If so, you need to key it in after pressing PROG 1
settings of my or PROG 2 before you can make any changes. If you've
handset and/or forgotten your PIN, you'll need to reset the handset
base unit, I hear and/or base unit as described on pages 26 and 31.
a warning
tone."
Indirect Network
"The Indirect You must subscribe to an alternative network
Network feature provider before you can use this feature.
isn't working."
If you have more than one registered handset, you need
to turn the feature on for each one individually, as well
as setting the network access code on the base unit.
When making a call, you must dial the number (or
select the number from memory, LNR memory or Caller
Display memory) before you press the PHONE button
for an outside line.
Binatone Help Line: 01325 304 473
Troubleshooting
37