Color profile: Generic CMYK printer profile
Composite
Default screen
Customising your handset
General points
You can customise the settings of your Big Button 510
handset, using a menu which is shown on the handset's
display. Please note that:
If you don't press any button for about 25 seconds,
the handset will time out and the display will return
to standby mode.
When you confirm any setting you have made, you'll
hear a confirmation tone. If you make a mistake,
you'll hear a warning tone.
At the end of each set of steps, you can return the
handset to standby mode by either:
replacing the handset on the base unit
—
pressing and holding the HANG UP/C button
—
Auto-answer
When a call comes in, you need to press any button to
answer it. Or you can set auto-answer — so, if the
handset is in place on the base unit, you simply lift it to
answer the call, without pressing any button.
1
Press the PROG button then 1 5
2
Use the
0 for auto-answer off
1 for auto-answer on
3
Press the PHONE/OK button to confirm
Binatone Help Line: 0845 345 9677
E:\Binatone2005\BigButton510\BigButton510_01.vp
27 February 2005 16:59:13
or
button to set:
23
(Local Call rate)