Fast Booting Systems With Intel ® Rapid Bios Boot; Peripheral Selection And Configuration; Intel Rapid Bios Boot - Intel D845GEBV2 - OCTOBRE 2002 Manual

3.9 Fast Booting Systems with Intel
These factors affect system boot speed:
•
Selecting and configuring peripherals properly
•
Using an optimized BIOS, such as the Intel Rapid

3.9.1 Peripheral Selection and Configuration

The following techniques help improve system boot speed:
•
Choose a hard drive with parameters such as "power-up to data ready" less than eight seconds,
that minimize hard drive startup delays.
•
Select a CD-ROM drive with a fast initialization rate. This rate can influence POST
execution time.
•
Eliminate unnecessary add-in adapter features, such as logo displays, screen repaints, or mode
changes in POST. These features may add time to the boot process.
•
Try different monitors. Some monitors initialize and communicate with the BIOS more
quickly, which enables the system to boot more quickly.

3.9.2 Intel Rapid BIOS Boot

Use of the following BIOS Setup program settings reduces the POST execution time.
In the Boot Menu:
•
Set the hard disk drive as the first boot device. As a result, the POST does not first seek a
diskette drive, which saves about one second from the POST execution time.
•
Disable Quiet Boot, which eliminates display of the logo splash screen. This could save
several seconds of painting complex graphic images and changing video modes.
•
Enabled Intel Rapid BIOS Boot. This feature bypasses memory count and the search for a
diskette drive.
In the Peripheral Configuration submenu, disable the LAN device if it will not be used. This can
reduce up to four seconds of option ROM boot time.
✏
NOTE
It is possible to optimize the boot process to the point where the system boots so quickly that the
Intel logo screen (or a custom logo splash screen) will not be seen. Monitors and hard disk drives
with minimum initialization times can also contribute to a boot time that might be so fast that
necessary logo screens and POST messages cannot be seen.
This boot time may be so fast that some drives might be not be initialized at all. If this condition
should occur, it is possible to introduce a programmable delay ranging from three to 30 seconds
(using the Hard Disk Pre-Delay feature of the Advanced Menu in the IDE Configuration Submenu
of the BIOS Setup program).
For information about
IDE Configuration Submenu in the BIOS Setup program
Overview of BIOS Features
® Rapid BIOS Boot
®
BIOS
Refer to
Section 4.4.4, page 103
93