IBM 8647 - Eserver xSeries 225 Installation Manual page 44

10. Push the drive cage outward, and press in on the drive-cage release tab; then,
11. If you have other options to install or remove, do so now; otherwise, replace
24
IBM xSeries 225 Type 8647: Installation Guide
page 25 for additional information about cabling drives and "System-board
internal connectors" on page 7 for the location of the SCSI connectors on the
system board. If there are open connectors on the cables connecting existing
SCSI drives, these cables can be used to connect the new drive.
8. Route the signal cable so that it does not block the air flow to the rear of the
drives or over the microprocessor and memory.
9. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
rotate the cage back into the server.
the support bracket (see "Removing and installing the support bracket" on
page 13) and then go to "Completing the installation" on page 34.