Removing The Side Cover - IBM 8647 - Eserver xSeries 225 Installation Manual

Removing the side cover

Complete the following steps to remove the side cover of the server:
1. Review the "Installation guidelines" on page 9.
2. Turn off the server and all attached devices (see "Turning on the server" on
3. Lay the server on its side.
4. Unlock the side cover; then, pull the cover-release latch away from the server,
Attention:
server. Operating the server with the cover removed might damage server
components.
page 38); then, disconnect all power cords and external cables.
and push the cover toward the rear of the server. Lift the side cover off the
server and set it aside.
Key lock
For proper cooling and airflow, replace the cover before turning on the
Cover-release
latch
Chapter 2. Installing options
11