Cisco WAP4410N - Small Business Wireless-N Access Point Administration Manual page 89

Specifications
WAP4410N Wireless-N Access Point with Power Over Internet
WAP4410N Specifications (Continued)
Multiple BSSID
VLANs
SSID to VLAN mapping
802.1x Supplicant
Spanning Tree
Operating Modes
Load Balancing
Auto-channel selection
802.11d
WEP/WPA/WPA2
Access Control
SSID Broadcast
Client Isolation
802.1x
802.1x Supplicant
Radius Server
WPS
Supports up to 4 BSSIDs allowing creating of multiple
virtual access points
Supports 802. 1 q - up to 4 VLANs
Supports mapping of SSIDs to VLANs to securely separate
workgroups across wireless and wired domains
Supports 802. 1 x Supplicant on the Ethernet port to allow
the AP to authenticate itself to the network
Supports 802. 1 d Spanning Tree protocol to prevent loops
when using WDS links as redundant links in a distribution
system
Access Point Mode, point-to-point Bridge Mode, point-to-
multipoint Bridge Mode, Repeater Mode, Wireless Client
Mode
This capability allows the bandwidth control with user
defined CPU usage ratio
On boot up, the AP selects the least congested channel
With 802. 1 1d Regulatory Domain support, the AP provides
radio channel settings for client devices facilitating easy
client access as they move across regulatory domains
WEP 64bit/128bit, WPA-TKIP, WPA2-AES,
WPA-Enterprise, and WPA2-Enterprise
Wireless Connection Control: MAC-Based
SSID Broadcast Enable/Disable
Supports wireless client isolation between SSIDs
Wireless clients can be authenticated through IEEE 802. 1 x
Supports 802. 1 x Supplicant on the Ethernet port to allow
the AP to authenticate itself to the network
Up to 2 Radius Servers can be configured for redundancy
purposes
Supports WPS (WiFi Protected Setup), which is a WIFI
Alliance specification for simple and secure setup of a
wireless network.
D
80