Chapter 5: Setting Up The Wap4410N Wireless-N Access Point; Launching The Web-Based Configuration Utility - Cisco WAP4410N - Small Business Wireless-N Access Point Administration Manual

Setting Up the WAP4410N Wireless-N Access
Point

Launching the Web-Based Configuration Utility

STEP 1
STEP 2
WAP4410N Wireless-N Access Point with Power Over Internet
The WAP4410N Access Point works right out of the box with the default settings.
However, you can change these settings to suit your needs by accessing the
access point using a web-based configuration utility.
The firmware v2.0.0.5 or later releases changed the factory default IP address
configuration to DHCP. Before installation, make sure your DHCP server is running
and can be reached. You may need to disconnect and reconnect the devices for
them to discover their new IP addresses from the DHCP server.
If the WAP4410N access point does not receive a DHCP response after 60
seconds, it falls back to the following default static IP address: 192. 1 68. 1 .245 and a
default mask of 255.255.255.0. For firmware releases earlier than v2.0.0.5, the
static IP address is 192. 1 68. 1 .245.
To configure the WAP4410N Access Point, follow these steps to access the
WAP4410N web-based configuration utility from your computer.
Connect the WAP4410N Access Point to the same network as your computer.
Locate the IP address of the WAP4410N Access Point by accessing your DHCP
server. Specific instructions on locating the DHCP address given to the
WAP4410N Access Point depends upon the type of architecture and operating
NOTE: Make sure you have Enabled TCP/IP
on your computers prior to proceeding.
Computers communicate over the network with
this protocol.
5
14