Ap Mode; Administration - Cisco WAP4410N - Small Business Wireless-N Access Point Administration Manual

Setting Up the WAP4410N Wireless-N Access Point
Navigating the Utility
WAP4410N Wireless-N Access Point with Power Over Internet
•
Basic Wireless Settings—Configures the wireless network mode (for
example, B/G/N-Mixed), SSID, and radio channel.
•
Wireless Security—Configures the access point's security settings.
•
Wireless Connection Control—Controls the wireless connections from
client devices to this access point.
•
Wi-Fi Protected Setup—Simplifies the process of setting up and
configuring security on a wireless network.
•
VLAN & QoS—Configures the 802. 1 Q VLAN and the Quality of Service
(QoS) settings.
•
Advanced Wireless Settings—Configures the access point's more
advanced wireless settings (for example, load balancing and channel
bandwidth).

AP Mode

This screen allows you to select the mode of operation for the access point. The
default mode is Access Point.

Administration

This screen allows you to manage the access point.
•
Management—Configures the password and Simple Network
Management Protocol (SNMP) settings.
•
Log—Configures the log settings.
•
Diagnostic—Allows you to perform diagnostic activities, which can be
useful in solving network problems.
•
Factory Default—Resets the access point to its factory default settings.
•
Firmware Upgrade—Upgrades the access point's firmware on this screen.
•
Reboot—Reboots the access point.
•
Config Management—Saves and restores access point configuration.
5
16