Diagnosing Access Point Problems - Cisco WAP4410N - Small Business Wireless-N Access Point Administration Manual

Configuring the WAP4410N Wireless-N Access Point
Administration
STEP 1
STEP 2
WAP4410N Wireless-N Access Point with Power Over Internet

Diagnosing Access Point Problems

The Administration > Diagnostics page allows you to use the access point to
perform a ping. The activity can be useful in solving network problems.
To perform a ping test to help diagnose problems with the access point, follow
these steps:
Click Administration > Diagnostics.
Set up the ping test:
•
IP or URL Address—Enter the IP address you want to ping. The IP address
can be on your network or on the Internet.
If the address is on the Internet, and no connection currently exists,
NOTE
you could get a timeout error. In that case, wait a few seconds and try
again.
•
Packet Size—Enter the size of the packet.
•
Times to Ping—Select the times to ping from the list.
•
Start to Ping—Click this button to start the ping procedure.
6
56