Issuing The Cisco Ios Command Using The Cli - Cisco Aironet 1240AG Series Hardware Installation Manual

Aironet 1240ag series
Hide thumbs Also See for Aironet 1240AG Series:
Table of Contents

Advertisement

Low Power Condition
Table 3-2
Using Cisco IOS Commands
Power Source
AC power module
Cisco switch that supports Intelligent Power
1
Management
Cisco switch that does not support Intelligent
1
Power Management
2
Power injector
used with a Cisco switch that
supports Intelligent Power Management
2
Power injector
used with a Cisco switch that
does not support Intelligent Power
1
Management
Power injector used with a non-Cisco switch
802.3af compliant non-Cisco switches
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ3 or AIR-PWRINJ-FIB.
3. The Cisco switch uses Intelligent Power Management to inform the access point of the power injector being used.
4. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.

Issuing the Cisco IOS Command Using the CLI

Follow these steps to issue the Cisco IOS command for your power scenario:
Step 1
Connect a PC to the access point console port and use a terminal emulator to establish a session with the
access point (refer to the
Step 2
From the global configuration mode (refer to the Cisco IOS Software Configuration Guide for Cisco
Aironet Access Points), enter the command below that applies to your power configuration (see
Table
Step 3
Enter the write memory command to save the setting to the access point memory.
Enter the quit command to exit the terminal session.
Step 4
Cisco Aironet 1240AG Series Access Point Hardware Installation Guide
3-10
Access Point
None required
no power inline negotiation prestandard source
no power inline negotiation injector
power inline negotiation prestandard source
no power inline negotiation injector
None required
1
no power inline negotiation prestandard source
power inline negotiation injector installed
None required
None required
"Connecting to the Access Point Locally" section on page
3-2):
power inline negotiation injector installed
no power inline negotiation injector
power inline negotiation prestandard source
no power inline negotiation prestandard source
Chapter 3
Troubleshooting 1240AG Series Autonomous Access Points
Cisco IOS Commands
3
Cisco Switch
power inline never
power inline auto
power inline auto
4
power inline never
power inline never
3-20).
OL-8371-05

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents