Direct Channel Search; Category Search; Checking The Xm Signal Strength And Radio - Denon TU-604CI - Multi-Zone Dual AM/FM Tuner Owner's Manual

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit and the remote control
unit
Button only on the main unit
Button only on the remote control unit
TUNING df <FUNCTION df>
<SEARCH>
Tuner select
indicators
[0 ~ 9]
[SRCH]
[uiop]


Direct Channel Search

1
Press
BUTTON
installed ACD-XMSIR (sold separately).
<BUTTON>
2
[BUTTON]
Press
<SELECT/ENTER>
TUNER SELECT
3
n Operation on the main unit
Turn
n Operation on the remote control unit
Press
Example:
b If no button is pressed within several seconds, the channel
automatically switches to the one whose number has been input.
4
Press
<RETURN/STATUS>
channel.
Reception switches to the selected channel.
TUNER SELECT

Category Search

1
Press
installed ACD-XMSIR (sold separately).
2
Press
After displaying "Category Search", the current channel category
is displayed.
TUNINGdf
[STATUS]
3
[ENTER]
Press
category, then turn
to select the desired channel.
TUNER SELECT
to select the tuner unit with
<SEARCH> [SRCH]
or .
SR---
DIRECT SEARCH
<SELECT/ENTER>
to set the channel number.
[0 ~ 9]
then input the channel number.
Accessing channel "XM123":
Press [1] [2] [3]
<SELECT/ENTER> [ENTER]
or to set that
TUNER SELECT
to select the tuner unit with
<FUNCTION > [o p]
df or .
Channel category
CAT: Rock
<FUNCTION > [o p]
df or to select the
<SELECT/ENTER>
or press
Checking the XM Signal Strength and
Radio ID
1
TUNER SELECT
Press to select the tuner unit with
installed ACD-XMSIR (sold separately).
2
<RETURN/STATUS>
Press
"SIGNAL" appears on the display.
The display will switch as shown below, depending on the
reception conditions.
Display
GOOD Signal strength is good
Signal strength is marginal
MARGINAL
WEAK Signal strength is weak
NO No signal
3
Adjust the position of the antenna until "SIGNAL:
GOOD" is shown on the display.
4
<RETURN/STATUS>
Press
channel you want to check (example: "XM001") is
displayed.
5
TUNING
Press df and select channel 0 (XM000).
The Sirius ID is shown on the display.
XM000 RADIO ID
The strength of both the XM satellite and terrestrial signals can be
checked at menu "Main Setup" – "Antenna Aiming" (vpage 16).
[ ]
ui
[STATUS]
or until
Status
[STATUS]
or until the
Radio ID