Option Setup; Dimmer; Remote Id Setup; Setup Lock - Denon TU-604CI - Multi-Zone Dual AM/FM Tuner Owner's Manual

ENGLISH

Option Setup

Make various other settings.
F Menu tree F
Main Setup
Option Setup
a Dimmer
s Remote ID Setup
d Setup Lock
f Ether Power
g RS-232C Power
h Maintenance
j Firmware Update
a Dimmer
Adjust display brightness of the TU-604CI.
[Selectable items]
Bright
: Normal display brightness.
Dim
: Reduced display brightness.
Dark
: Very low display brightness.
OFF
: Display is off unless controls are operated.
Operating from the main unit or remote
control unit

DIMMER

Press .
Bright
OFF
When setting to "OFF", the display brightness changes to "Dark"
for about 5 seconds during the operation before reverting to the set
brightness.

s Remote ID Setup
Set TU-604CI's remote control ID.
Match the ID setting of the remote control unit and the TU-
604CI.
Set a different number for remote ID of each unit when using
multiple TU-604CI units.
[Selectable items]
See "Setting the Remote ID" (vpage 38) for setting remote ID on
the remote control.
d Setup Lock
Protect settings from inadvertent change.
[Selectable items]
ON
: Turn protection on.
OFF
: Turn protection off.
To cancel the setting, press
then change the setting to "OFF".
Dim
Dark
1 2 3 4
SETUP
to re-display the "Setup Lock",
f Ether Power
Sets Ethernet power status when TU-604CI power is standby.
Set to "ON" when using the web control function.
When "ON" is set, Ethernet function power is applied even when
the TU-604CI power is on standby.
[Selectable items]
ON
: Using the web control function. (Performs TU-604CI power
ON/OFF via network.)
OFF
: Without using the web control function.
Setting to "OFF" allows you to curb power consumption during
standby.
g RS-232C Power
Sets RS-232C control function power status when TU-604CI
power is on standby.
Set to "ON" when performing main unit ON/STANDBY via the
RS-232C control function.
When "ON" is set, RS-232C control function power is applied
even when the TU-604CI power is on standby.
[Selectable items]
ON
: Performs ON/STANDBY operation of main unit power via
the RS-232C control function.
OFF
: Does not perform ON/STANDBY operation of main unit
power via the RS-232C control function.
Setting to "OFF" allows you to curb power consumption during
standby.