Connecting The External Controller; Connecting The Power Cord; Once Connections Are Completed - Denon TU-604CI - Multi-Zone Dual AM/FM Tuner Owner's Manual

Connecting the External Controller

MASTER TRIGGER OUTPUT jack
The power of an external device equipped with a trigger input jack can be turned on and off in association
with operations on the TU-604CI.
• Output level: 250 mA / 12 V
Check the trigger input conditions of the connected device.
TRIGGER OUTPUT jacks (1 ~ 6)
TRIGGER OUT jack of TUNER-1 ~ 6 outputs a trigger voltage when the power of each tuner is turned
on.
Turning power on/off of equipment connected to this jack can be linked to the power of the TU-604CI.
• Output level: 250 mA / 12 V
Check the trigger input conditions of the connected device.
RS-232C connector
This connector is used for an external controller.
b If you wish to control the TU-604CI from an
external controller using the RS-232C connector,
perform the operation below beforehand.
q Turn on the TU-604CI's power.
w Turn off the TU-604CI's power from the external
controller.
e Check that the TU-604CI is in the standby mode.
ROOM TO ROOM REMOTE CONTROL jacks
Input
Infrared retransmitter

Connecting the Power Cord

Wait until all connections have been completed before connecting the power cord.
NOTE
Insert the AC plugs securely. Incomplete connections could cause noise.

Once Connections are Completed

Turning the Power On
(vpage 21)
Output
Extension jack for future use.
Infrared sensor
Power cord
(supplied)
To household
power outlet
North America model
AC 120 V, 60 Hz
To household
power outlet
Europe model
AC 230 V, 50 Hz
ENGLISH