Panasonic WV-SW352 Installation Manual page 17

SDHC/SD
memory card slot
Monitor out
connector for
adjustment
About the initial set button
After turning off the power of the camera, turn on the power of the camera while holding down this
button, and wait for around 5 seconds or more without releasing the button. Wait around 2 minutes
after releasing the button. The camera will start up and the settings including the network settings
will be initialized. Before initializing the settings, it is recommended to write down the settings in
advance. Do not turn off the power of the camera during the process of initialization.
Before initializing the settings, it is recommended to copy down the settings in advance.
TOP
MONITOR
INITIAL
Initial set button
MONITOR
OUT
INITIAL
SET
AF/EXTRA
OPTICAL
ZOOM
LINK
Link indicator
(lighting at linking)
Access indicator (blinking at accessing)
LOCK
TOP
OUT
SET AF/EXTRA
HEATER
OPTICAL
SD CARD
ZOOM
/AF
LINK
ACT
Auto focus (AF) button/
Extra optical zoom button
HEATER
SD CARD
/AF
ACT
SD memory card error indicator/
Auto focus indicator
(blinking at adjusting auto focus)
Panning lock screw
Panning table
Heater unit (option) connector
17