Dish Network DuoDVR ViP 722_TOC User Manual page 47

YP P C
B R ONNECTIONS
The YPbPr (component) connections provide high-quality video to your HDTV or HD
monitor.
1
SYSTEM INFO
Connect receiver
and monitor with
YPbPr Component
connections
1
Connect between the YP
using component video cables.
2
Connect audio (red and white) RCA-type cables between the receiver A
audio input connections that go with the YPbPr connectors on your HDTV or monitor.
3
If you do not see a picture, change the resolution setting on the receiver. Use the steps
below and Setting Up to Display in HD on the next page.
4
Turn up the volume on your HDTV and confirm you have sound. Check the RCA-type
connections if you don't have sound.
No Picture on the Nearby TV
This section will help you make a picture on the nearby TV in the event that you could not
do so in the previous sections.
1
Connect RCA-type cable connections between the receiver TV1 Out and the nearby TV.
2
Make sure the receiver and nearby TV are on.
3
Make sure the nearby TV is set to use the RCA-type inputs. Look on the back of your
HDTV and consult your HDTV user's guide.
4
Change the HDTV settings as described on page 102.
5
Switch to the nearby TV to display from the HD inputs you selected in the previous
sections. If you have a picture from TV1, you are finished.
6
Repeat steps 4 and 5 until the nearby TV displays video from the receiver.
2
SYSTEM INFO
AUDIO
Connect receiver
and monitor with
Audio cables
P component connections on the receiver and the nearby TV
B R
Connections and Setup
YPbPr Connections
L
3
R
Turn monitor
Confirm
and receiver on
sound and
and confirm
volume
picture
O
UDIO UTPUTS
4
and
101