Cf_ Fancontrol Command; Cf_ Lamplifere Command; Cf_ Rcode Command; Cf_Freeze Command - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

PDG-DWL100 Expand Serial Command Functional Specifications

8.10.8 CF_ FANCONTROL Command

Command "CFÿ ? FANCONTROLÿ ? %1" [CR]
"ON" ------------------------------ Set On
%1
"OF" ------------------------------ Set Off
Select Fan control. (Valid only when in the normal Power ON status.)
The status set by this command is stored in EEPROM and the setting
Details
remains effective after the power is turned to ALL OFF status.
No display is shown when projector received command..
Acceptable
Correspondence
Unacceptable

8.10.9 CF_ LAMPLIFERE Command

Command "CF_LAMPLIFERE_%1" [CR]
"ON" ------------------------------ Set On
%1
"OF" ------------------------------ Set Off
Select Lamp life Reminder. (Valid only when in the normal Power ON status.)
The status set by this command is stored in EEPROM and the setting
Details
remains effective after the power is turned to ALL OFF status.
No display is shown when projector received command..
Acceptable
Correspondence
Unacceptable

8.10.10 CF_ RCODE Command

Command "CF_RCODE_%1" [CR]
"001" --------------------------- Select Code1
"002" --------------------------- Select Code2
"UP" --------------- Switch Code setting of Remote Control forward
%1
"DN" --------------- Switch Code setting of Remote Control backward
Select Code of Remote Control
The status set by this command is stored in EEPROM and its setting is
Details
effective after ALL is OFF
This command is available in normal Power ON status.
Acceptable
Correspondence
Unacceptable

8.10.11 CF_FREEZE Command

Command "CF_FREEZE_%1" [CR]
"ON" -----------------------------Set Freeze on
"OFF" ----------------------------Set Freeze off
%1
"UP" -----------------------------Switch the status forward (On→Off→On→....)
"DN" ---------------------------- Switch the status backward (Off→On→Off→....)
Set freeze on/off.
In order to release FREEZE mode, it needs to send the same number of
Details
CF_FREEZE_OFF.
No display is shown when projector received command.
Acceptable
Correspondence
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
(Code1 → Code2 → Code1)
(Code1 → Code2 → Code1)
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
27 / 47