Functional Execution Command; Format; Transfer Example; Operation Requirements - Sanyo PDG-DWL100 - WXGA DLP Projector Command Manual

Rs232c expand
Hide thumbs Also See for PDG-DWL100 - WXGA DLP Projector:
Table of Contents

Advertisement

PDG-DWL100 Expand Serial Command Functional Specifications
8
Functional Execution CommandFormat
PC issues a command in the format below:
Pattern1: "CF_Command" [CR]
Pattern2: "CF_Command_" %1 [CR]
CF_: Header
Command: Text
%1: Parameter (Text)
_:
The projector decodes the received command and when it gets ready to receive another
command, it returns the Correspondence.
"000" [CR]: (0x06, 0x0D) When the projector receives the Functional Execution
Command.
"nnn" [CR]: Except "000", when it cannot execute commands for some specific reason.
When the projector cannot decode the command, it returns "?" [CR].

8.2 Transfer Example

When setting projector's total dots to 1344 by Expand Command.
PC → PJ: "CF_TDOTS_1344" [CR]
PC ← PJ: "000" [CR] ---------------- Acceptable

8.3 Operation Requirements

Functional Execution Commands are limited in the status bellow/
(Status Read Commands are available in following status.)
Projector Status
In Standby Mode
Cooling Down in process
Cooling
Down
abnormal temperature
In Abnormal Temperature
Power Failure
(For 60 seconds after Power failed.)
Note) The projector returns an appropriate error code when it receives other command in the
above status.
Space (To separate Command and Parameter)
Refer to [7. Error Code Table] for detail.
Available Functional Execution Command
C00: POWER ON
NONE (No Execution)
in
process
due
to
NONE (No Execution)
NONE (No Execution)
NONE (No Execution)
14 / 47

Advertisement

Table of Contents
loading

Table of Contents