Specifying Settings In Utility Menu; General Procedure For Specifying Settings In Utility Menu; Memory Reception - Konica Minolta bizhub C20/C20X Facsimile Manual

Specifying Settings in Utility Menu

General Procedure for Specifying Settings in Utility
Menu
1
Press the + or , key to select UTILITY, and then press the Select key.
2
Press the + or , key to select the desired menu, and then press the
Select key to display the selected menu.
3
To select a setting, press the +, ,, * or ) key.
To enter a setting, use the keypad to type in the number.
4
Press the Select key.
The setting is applied.

Memory Reception

Received faxes can be stored in the memory and printed at a specified time.
This is convenient, for example, when confidential documents are received.
Memory reception can be used with the following settings.
Start/end time settings: Not set
MEMORY RX MODE function is normally set to
in memory, set MEMORY RX MODE function to
Start/end time settings: Set
Memory reception mode begins and ends at the specified time.
Example 1: When ON TIME setting is set to 18:00 and OFF TIME setting
is set to 8:00
The machine is in memory reception mode from 18:00 to 8:00 and in
normal reception mode, where faxes are printed after being received,
from 8:00 to 18:00.
Example 2: When ON TIME setting is set to 12:00 and OFF TIME setting
is set to 12:00 (the start time and end time are the same)
MEMORY RX MODE function is normally set to
saved in memory are printed at 12:00.
34
Refer to the menu configuration on page 11 to display the desired
menu.
To cancel the settings, press the Back key.
Specifying Settings in Utility Menu
. To print a fax saved
ON
.
OFF
; however, faxes
ON