Control Panel Reset; Dynamic Massage Sequencer; Control Panel Description - Dimension One Spas Bay Collection Owner's Manual

Control Panel Reset

This function is used to completely reset the clock and all other system variables to the factory defaults. Please
keep in mind that this resets all maintenance messages (clean filters, change water, etc.) as if the hot tub is
being installed the day of the panel reset. To reset the control system all of the following buttons must be
pushed within 3 seconds:
1. Push the ICON (logo) Button
2. Push the ENTER Button
3. Push the PROGRAM Button
The top line of the Digital Display Window will read "RESET PROGRAMMING?"
The bottom line of the Digital Display Window will read "IF SO, PUSH ICON"
4. Push the Dimension One ICON Button to reset the entire control system to factory defaults or do
not touch a button for 10 seconds to exit.

Dynamic Massage Sequencer

The Dynamic Massage Sequencer is located in the Ultra Lounge of the models mentioned above. The
sequencer directs a succession of 14 jets to six separate muscle groups.
When a sequence is chosen, a human figure with LED's defining each zone, will light, showing the active zones
in that sequence. This allows you to preview the zones in the sequence before a selection is confirmed.

Control Panel Description

LIGHT Button
2004 Bay Collection
Owner's Manual
The LIGHT Button is used to turn the spa light on or off. The status light below
the button will illuminate when the light is on. The spa light may be turned on/off
with this button, or the one on the Top Side Control. They work interchangeably.
35