Filter Cycle Duration; Number Of Filter Cycles; Pump Run Time; Temperature Unit Selection - Dimension One Spas Bay Collection Owner's Manual

During a filter cycle, the bottom left of the Digital Display Window will read "SPA FILTERING". During the
filter cycle, JETS 1 will activate, the first 5 minutes at high speed and the remainder of the filter cycle time at
low speed. JETS 2 will also activate for 1 minute on high speed and then turn off.

Filter Cycle Duration

After setting the filter cycle start time, the top line of the Digital Display Window will read "SET CYCLE
DURATION". Push the UP or DOWN Buttons to toggle between 10, 20, 30, 40, 50, or 60 minutes. The
filter cycle will be at low speed. When your desired filter cycle length appears in the Digital Display Window,
push the PROGRAM Button to select it. The pre-set factory default is 20 minutes.

Number of Filter Cycles

After setting the length of the filter cycle, you will be prompted to set the number of filter cycles. The top line
of the Digital Display Window will read "SET # OF CYCLES". Push the UP or DOWN Button to toggle
between 1, 2, 3, or 4 cycles per day. When your desired number of cycles appears on the Digital Display
Window, push the PROGRAM Button to select it. The pre-set factory default is 1 cycles per day.
Long and/or numerous filter cycles could cause overheating of the hot tub - especially in hot
climates.

Pump Run Time

After setting the number of filter cycles, the top line of the Digital Display Window will read "SET PUMP
RUN TIME". Push the UP or DOWN Button to toggle between 30, 45 and 60 minutes. This sets the
length of time the pump will run when a jets Button is pushed. For example, if you choose 45 minutes, when
you push a jets Button, the pump will run for 45 minutes before shutting down automatically. When your
desired pump run time appears on the Digital Display Window push the PROGRAM Button to select it. The
pre-set factory default is 30 minutes.

Temperature Unit Selection

After setting the pump run time, the top line of the Digital Display Window will read "SET
TEMPERATURE UNITS". Push the UP or DOWN Buttons to toggle from °F to °C. When your
desired temperature unit appears in the Digital Display Window, push the PROGRAM Button to select it.
The pre-set factory default is Fahrenheit.

Vision Cartridge

After setting the temperature units, the top line of the Digital Display Window will read "SET VISION
CARTRIDGE". Push the UP or DOWN Buttons to toggle between "Yes" and "No". If you are currently
using a Vision Cartridge select Yes, if not, select No. Selecting "Yes" will prompt the control to notify you
when your cartridge needs replacement. When your desired selection appears in the Digital Display Window,
push the PROGRAM Button to select it. The pre-set factory default is "No."

Waterfall Run Time

After choosing the Vision Cartridge setting, the top line of the Digital Display Window will read "SET
WATERFALL RUN TIME". Push the UP or DOWN Buttons to toggle between 1, 2, 3, or 4 hours. For
example, if you choose 2 hours, when you push the Water Feature Button, the Waterfall will run for 2
hours before shutting down automatically. The pre-set factory default is "1."
2004 Bay Collection
Owner's Manual
33