Standby Mode; Programming The Scrolling Message Center; Setting The Time; Filter Cycle Start Time - Dimension One Spas Bay Collection Owner's Manual

Standby Mode

Programming the Scrolling Message Center

Your Scrolling Message Center is the most advanced in the industry and can virtually walk you through
customizing your hot tub to your exact needs. To initiate the programming sequence at any time, push and
hold the Program Button for 3 seconds. If, within 10 seconds, you do not proceed with the hot tub
programming, the hot tub will automatically exit the programming sequence and revert to the pre-set factory
default settings. To exit the programming sequence at any time, push the Enter Button or do not press any
button for 10 seconds. Any programming changes made up to that point are saved.

Setting the Time

After holding the PROGRAM Button, the top line of the Digital Display Window will read "SET TIME OF
DAY" and the bottom line will read "PUSH UP OR DOWN TO CHANGE - PUSH PROGRAM TO
SELECT NEXT FUNCTION - PUSH ENTER TO EXIT ". Push the UP or DOWN Buttons to engage the
time setting mode. The time screen will appear with "hours" (_ _.00) flashing on and off. Push the UP or
DOWN Button to increase or decrease the number until the desired hour appears. When the desired
number is displayed, push the LIGHT Button to accept the selection and change the flashing number to the
"ten minute" place (12:_0). Adjust the number with the UP or DOWN Button in the same manner as the
hour number. When the desired indicator is displayed, push the LIGHT Button to accept the selection and
change the flashing number to the "minute" place (12:1_). Adjust this number with the UP or DOWN
Button in the same manner as the hour number. When the desired number is displayed, push the LIGHT
Button to accept the selection and change the flashing number to a flashing AM or PM indicator. Adjust the
indicator with the UP or DOWN Buttons. After reaching the correct time, push the PROGRAM Button
to set the time and exit the time setting mode. You will then be prompted to set the filter start time.

Filter Cycle Start Time

After setting the time-of-day, the top line of the Digital Display Window will read "SET FILTER CYCLE
TIME". Push the UP or DOWN Buttons in the same manner as setting the clock to select the time you
want your filter cycle to start. When your desired filter cycle start time is set in the display, push the
PROGRAM Button to continue. The pre-set factory default is 12:00 p.m. to 1:00 p.m. repeating every 12 hours
unless the number of filter cycles per day has been changed.
Keep in mind that you will later be prompted to set the filter cycle duration and the number of
filter cycles. Be sure to keep this in mind when programming your filter cycle start time.
32
2004 Bay Collection
Owner's Manual
The "STANDBY" mode allows the user to clean the filter without turning off
power to the spa. This feature disables all automatic and manual functions.
To enter the "STANDBY" mode press and hold the Dimension One Spa's
ICON Logo® Button for 5 seconds. To exit the mode, press and hold the
Logo Button for 5 seconds.
If you do not exit the mode manually, the spa will automatically return to
normal functionality after 24 hours.
The "Smart Winter" mode is not affected by the use of the
"Standby": mode.