Cisco WS-X6148-GE-TX - Switch Hardware Installation Manual page 62

Replacing or Installing Components
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Step 3 Grasp the handle of fan module and pull it outward as shown in
Figure 2-16
Figure 2-17
Pull the fan module clear of the chassis and set it down on antistatic foam or place it in an antistatic bag.
Step 4
Step 5 Hold the replacement fan module with the LED at the bottom.
Step 6 Place the fan module into the front chassis cavity so it rests on the chassis, and then push the fan module
into the chassis as far as it can go and the captive screw makes contact with the chassis, and tighten the
captive screw. See
Listen for the fans if the system is powered on. You should immediately hear them operating. If you do
Step 7
not hear them, ensure that the fan module is inserted completely in the chassis and the faceplate is flush
with the outside surface of the chassis.
Verify that the LED is green. If the LED is not green, one or more fans are faulty. If this occurs, contact
Step 8
your customer service representative for a replacement part.
Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide
2-28
Fan Module for the Cisco UCS 6120XP
Fan Module for the Cisco UCS 6140XP
Figure 2-16.
Chapter 2 Installing the Cisco UCS 6100 Series Fabric Interconnect
Figure 2-16 or Figure 2-17.
OL-20036-02