Cisco WS-X6148-GE-TX - Switch Hardware Installation Manual page 50

Grounding the System
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Figure 2-9
1 ESD ground strap
3
Side view of grounding lug (clip slid behind
screw)
5
System ground connector
Note
In addition, follow these guidelines when handling modules:
• Handle carriers by available handles or edges only; avoid touching the printed circuit boards or
connectors.
• Place a removed component board-side-up on an antistatic surface or in a static-shielding container.
If you plan to return the component to the factory, immediately place it in a static-shielding
container.
Never attempt to remove the printed circuit board from the metal carrier.
•
Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide
2-16
Attaching the ESD Wrist Strap to the Cisco UCS 6120XP System Ground Lug Screw
If you are using the ESD wrist strap that is supplied with the FRUs, squeeze the spring clip jaws
open, position the spring clip to one side of the system ground lug screw head, and slide the
spring clip over the lug screw head so that the spring clip jaws close behind the lug screw head.
The spring clip jaws do not open wide enough to fit directly over the head of the lug screw
or the lug barrel.
If you are using an ESD wrist strap that is equipped with an alligator clip, attach the alligator
clip directly over the head of the system ground lug screw or to the system ground lug barrel.
Chapter 2 Installing the Cisco UCS 6100 Series Fabric Interconnect
1
2 Clip and grounding lug
4
Clip installed (behind screw)
5
2
3
4
OL-20036-02