Grounding The Chassis - Cisco WS-X6148-GE-TX - Switch Hardware Installation Manual

Grounding the Chassis

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Grounding the Chassis
The chassis has a grounding pad with two threaded M4 holes for attaching a grounding lug.
shows how to ground the Cisco UCS 6120XP.
When installing or replacing the unit, the ground connection must always be made first and
Warning
disconnected last. Statement 1046
Caution We recommend grounding the chassis, even if the rack is already grounded.
All power supplies must be grounded. The receptacles of the AC power cables used to provide power to
Caution
the chassis must be the grounding type, and the grounding conductors should connect to protective earth
ground at the service equipment.
Figure 2-10
1 Grounding cable
3 NRTL listed grounding lug
Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide
2-18
Grounding the Cisco UCS 6120XP Fabric Interconnect
2 Screws, M4, with square cone washers
4 Close-up of grounding pad on the chassis
Chapter 2 Installing the Cisco UCS 6100 Series Fabric Interconnect
Figure 2-11 shows how to ground the Cisco UCS 6140XP.
4
3
Figure 2-10
1
2
OL-20036-02