Installing A Power Supply - Cisco WS-X6148-GE-TX - Switch Hardware Installation Manual

Replacing or Installing Components
S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m
Step 3 Push against the release latch with your left thumb and slide the power supply out of the chassis. See
Figure 2-14
Figure 2-14
Figure 2-15
Place your right hand under the power supply to support it while you slide it out of the chassis.
Step 4
If you are not replacing the power supply, install a blank power supply filler panel (N10-S1BLKP= or
Step 5
N10-S2BLKP=). If you are replacing the power supply, see

Installing a Power Supply

To install a power supply, follow these steps:
Ensure that the system (earth) ground connection has been made. For ground connection instructions,
Step 1
see the
Cisco UCS 6100 Series Fabric Interconnect Hardware Installation Guide
2-26
or Figure 2-15.
Removing the Power Supply for the Cisco UCS 6120XP
Removing the Power Supply for the Cisco UCS 6140XP
"Grounding the System" section on page
Chapter 2 Installing the Cisco UCS 6100 Series Fabric Interconnect
Installing a Power Supply, page
2-11.
2-26.
OL-20036-02