Connecting To A Local Area Network (Lan); Connecting A Network Cable; Leds On The Network Port - Konica Minolta bizhub 215 User Manual

2.2

Connecting to a local area network (LAN)

2.2 Connecting to a local area network (LAN)
This machine establishes LAN connection using the TCP/IP protocols. To do this, you need to connect this
machine to a LAN using a network cable.
Tips
- The explanation contained in this manual assumes that the Network Card NC-504 or Image Control-
ler IC-209 is installed on this machine. This machine requires the Network Card NC-504 or Image
Controller IC-209 to connect to a network. Ensure that either of them is installed in this machine.
2.2.1

Connecting a network cable

Insert one connector of a network cable into the network port (LAN) on the left side of the main unit, and insert
the other connector into an available port on the network hub.
Tips
- Use a network cable rated at category 5, 5E, or higher. Note that a network cable is not supplied to-
gether with this machine.

LEDs on the network port

LED1 (LINK):
LED2 (ACT):
bizhub 215
LED1
LED2
This LED lights up when the network cable is correctly connected. If this LED does
not light up even though you have correctly connected the cable, check the connec-
tion. If this LED does not light up even though the both ends of the network cable
are correctly connected, the cable may have been broken.
This LED flashes during data transmission or reception.
2
2-3