Connecting The Network Cable; Affixing The Paper Size Label - Konica Minolta Bizhub c554e Installation Manual

XXIII. Changing the stopper position
1. Raise the two hinge covers on the back of the
dual scan document feeder and remove the stop-
per from the hinge of the dual scan document
feeder.
2. Change the set position of the stopper to the
upper side and secure it in position.
Stopper
XXIV. Affixing the paper size label
Affix the paper size labels that correspond to the
sizes of paper used in each tray.
Paper size label
For loading the paper as well as setting the paper
type, refer to the user's guide.
XXV. Check through test print
Make operation checks using "Setting Information
Print."
1. Select the function to be used as follows:
Menu → Utility → User Settings → Printer Set-
tings → Print Reports.
The types of the test prints that can be printed will
be displayed.
2. Touch "Configuration Page."
3. Touch A4 size and press the start key.
Check that the machine produces the corre-
sponding printed page.
4. Touch "Cancel" and then touch "Close" four
times.
XXVI. Connecting the network cable
1. Connect the networking equipment (HUB) using
the network cable.
Note:
The following shows the recommended network
cables that correspond to each communication
speed.
• 10BaseT/100BaseTX: Category 5
• 1000BaseT: Category 5E, Category 6
A3CEIXE047DB
Networkport
2. Check LEDs for lighting conditions.
LED1:
Should light up steadily if the link network con-
nection has been made.
LED2:
Should blink according to the communications
status of the ACT network.
A161IXC026DA
E-20
LED1
LED2
A5C1IXC008DB