Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual page 648

Chapter 32 Configuring IP Unicast Routing
Table 32-5 Default OSPF Configuration (continued)
Feature
Area
Auto cost
Default-information originate
Default metric
Distance OSPF
OSPF database filter
IP OSPF name lookup
Log adjacency changes
Neighbor
Neighbor database filter
Network area
Router ID
Summary address
Timers LSA group pacing
Timers shortest path first (spf)
Virtual link
78-17058-01
Default Setting
Authentication type: 0 (no authentication).
Default cost: 1.
Range: Disabled.
Stub: No stub area defined.
NSSA: No NSSA area defined.
100 Mbps.
Disabled. When enabled, the default metric setting is 10, and the external route type
default is Type 2.
Built-in, automatic metric translation, as appropriate for each routing protocol.
dist1 (all routes within an area): 110.
dist2 (all routes from one area to another): 110.
and dist3 (routes from other routing domains): 110.
Disabled. All outgoing link-state advertisements (LSAs) are flooded to the interface.
Disabled.
Enabled.
None specified.
Disabled. All outgoing LSAs are flooded to the neighbor.
Disabled.
No OSPF routing process defined.
Disabled.
240 seconds.
spf delay: 5 seconds.
spf-holdtime: 10 seconds.
No area ID or router ID defined.
Hello interval: 10 seconds.
Retransmit interval: 5 seconds.
Transmit delay: 1 second.
Dead interval: 40 seconds.
Authentication key: no key predefined.
Message-digest key (MD5): no key predefined.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring OSPF
32-25