Table of Contents
Advertisement
Chapter 5
Administering the Switch
If the switch is running the metro IP access or metro access image, you can disable MAC address
learning on a per-VLAN basis. Customers in a service provider network can tunnel a large number of
MAC addresses through the network and fill up the available MAC address table space. You can control
MAC address learning on a VLAN and manage the MAC address table space that is available on the
switch by controlling which VLANs, and therefore which ports, can learn MAC addresses.
Before you disable MAC address learning, be sure that you are familiar with the network topology and
the switch system configuration. Disabling MAC address learning on a VLAN could cause flooding in
the network. See the
information.
Default MAC Address Table Configuration
Table 5-3
Table 5-3
Feature
Aging time
Dynamic addresses
Static addresses
MAC address learning on VLANs
Changing the Address Aging Time
Dynamic addresses are source MAC addresses that the switch learns and then ages when they are not in
use. You can change the aging time setting for all VLANs or for a specified VLAN.
Setting too short an aging time can cause addresses to be prematurely removed from the table. Then
when the switch receives a packet for an unknown destination, it floods the packet to all ports in the same
VLAN as the receiving port. This unnecessary flooding can impact performance. Setting too long an
aging time can cause the address table to be filled with unused addresses, which prevents new addresses
from being learned. Flooding results, which can impact switch performance.
78-17058-01
"Disabling MAC Address Learning on a VLAN" section on page 5-26
shows the default MAC address table configuration.
Default MAC Address Table Configuration
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Default Setting
300 seconds
Automatically learned
None configured
Enabled
Managing the MAC Address Table
for more
5-21
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
