Displaying The Sdm Templates - Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual

Displaying the SDM Templates

This example shows how to configure a switch with the layer-2 template.
Switch(config)# sdm prefer layer-2
Switch(config)# end
Switch# reload
Proceed with reload? [confirm]
Displaying the SDM Templates
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | layer-2] privileged EXEC command to display the resource numbers
supported by the specified template.
This is an example of output from the show sdm prefer default command:
Switch# show sdm prefer default
"default" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses:
number of IPv4 IGMP groups + multicast routes:
number of IPv4 unicast routes:
number of IPv4 policy based routing aces:
number of IPv4/MAC qos aces:
number of IPv4/MAC security aces:
This is an example of output from the show sdm prefer layer-2 command:
Switch# show sdm prefer layer-2
"layer-2" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses:
number of IPv4 IGMP groups:
number of IPv4 multicast routes:
number of unicast IPv4 routes:
number of IPv4 policy based routing aces:
number of IPv4/MAC qos aces:
number of IPv4/MAC security aces:
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
6-4
number of directly-connected IPv4 hosts:
number of indirect IPv4 routes:
Chapter 6 Configuring SDM Templates
1K
1K
5K
1K
4K
512
512
1K
8K
1K
0
0
0
512
1K
78-17058-01