Cisco ME 3400G-2CS - Ethernet Access Switch Software Configuration Manual page 50

Default Settings After Initial Switch Configuration
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature
Tunneling
• 802.1Q tunneling (requires
metro IP access or metro access
image)
• Layer 2 protocol tunneling
(requires metro IP access or
metro access image)
Spanning Tree Protocol
STP
•
MSTP
•
• Optional spanning-tree features
Flex Links (requires metro IP access
or metro access image)
DHCP snooping
IP source guard (requires metro IP
access or metro access image)
IGMP snooping
• IGMP snooping
IGMP filters
•
IGMP querier
•
• MVR
IGMP throttling
Port-based Traffic Control
• Broadcast, multicast, and unicast
storm control
• Protected ports
Unicast and multicast traffic
•
flooding
Secure ports
•
CDP
UDLD
SPAN and RSPAN
RMON
Syslog messages
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
1-10
Default Setting
Disabled
Disabled
Rapid PVST+ enabled on NNIs in
VLAN 1
Disabled (only supported on NNIs)
Disabled (only supported on NNIs)
Not configured
Disabled
Disabled
Enabled
None applied
Disabled
Disabled
Deny
Disabled
None defined
Not blocked
None configured
Enabled (supported only on NNIs)
Disabled
Disabled
Disabled
Enabled; displayed on the console
More information in...
Chapter 13, "Configuring IEEE 802.1Q
and Layer 2 Protocol Tunneling"
Chapter 14, "Configuring STP"
Chapter 15, "Configuring MSTP"
Chapter 16, "Configuring Optional
Spanning-Tree Features"
Chapter 17, "Configuring Flex Links"
Chapter 18, "Configuring DHCP Features
and IP Source Guard"
Chapter 18, "Configuring DHCP Features
and IP Source Guard"
Chapter 20, "Configuring IGMP Snooping
and MVR"
Chapter 20, "Configuring IGMP Snooping
and MVR"
Chapter 21, "Configuring Port-Based
Traffic Control"
Chapter 22, "Configuring CDP"
Chapter 23, "Configuring UDLD"
Chapter 24, "Configuring SPAN and
RSPAN"
Chapter 25, "Configuring RMON"
Chapter 26, "Configuring System Message
Logging"
Chapter 1 Overview
78-17058-01