MSI NF980-G65 - Motherboard - ATX User Manual page 64

▶ DRAM Advance Control
Ths field has the capacty to automatcally detect the advanced DRAM tmng. If you
set ths field to [DCT 0], [DCT 1] or [Both], some fields wll appear and selectable.
▶ 1T/2T Memory Tmng
Ths tem controls the SDRAM command rate. Select [1T] makes SDRAM sgnal
controller to run at 1T (T=clock cycles) rate. Selectng [2T] makes SDRAM sgnal
controller run at 2T rate.
▶ DCT Unganged Mode
Ths feature s used to Integrate two 64-bt DCTs nto a 128-bt nterface.
▶ Bank Interleavng
Bank Interleavng s an mportant parameter for mprovng overclockng capablty of
memory. It allows system to access multple banks smultaneously.
▶ Power Down Enable
Ths s a memory power-savng technology. When the system does not access mem-
ory over a perod of tme, t wll automatcally reduce the memory power supply.
▶ MemClk Trstate C3/ATLVID
Ths settng allows you to enable/dsable the MemClk Trstatng durng C3 and
ATLVID.
▶ FSB/DRAM Rato
Ths tem allows you to select the rato of FSB/ DRAM.
▶ Adjusted DRAM Frequency (MHz)
It shows the adjusted Memory frequency. Read-only.
▶ HT Lnk Speed
Ths tem allows you to set the Hyper-Transport Lnk speed. Settng to [Auto], the sys-
tem wll detect the HT lnk speed automatcally.
▶ HT Lnk Wdth
These tems allow you to set the Hyper-Transport Lnk wdth. Settng to [Auto], the sys-
tem wll detect the HT lnk wdth automatcally.
▶ CPU VDD Voltage (V)/ CPU-NB VDD Voltage (V)/ CPU Voltage (V)/ CPU-NB Voltage
(V)/ DRAM Voltage (V)/ NB Voltage (V)/ HT Lnk Voltage (V)
These tems are used to adjust the voltage of CPU, Memory and chpset.
▶ CPU Spread Spectrum
Ths tem s used to enable/ dsable CPU spread spectrum.
MS-7612 MS-7612
3-23