Memorex MVDT2002SM Service Manual page 19

2-14: MAIN CAM/PINCH ROLLER CAM/JOINT GEAR
(Refer to Fig. 2-14-A)
Remove the E-Ring 1, then remove the Main Cam.
1.
Remove the E-Ring 2, then remove the Pinch Roller
2.
Cam and Joint Gear.
NOTE
1. In case of the Pinch Roller Cam and Main Cam
installation, install them as shown in the circled section
of Fig. 2-15-B so that the markers meet. (Refer to Fig.
2-14-B)
And also can be seen the Main Chassis hole through the
Main Cam maker hole.
Pinch Roller Cam
Marker
Main Cam
2-15: LOADING GEAR S/T UNIT (Refer to Fig. 2-15-A)
Remove the E-Ring 1 and remove the Main Loading
1.
Gear.
2. Remove the Main Rod, Tension Lever, Loading Arm S
Unit and Loading Arm T Unit.
Main Rod
Tension Lever
DISASSEMBLY INSTRUCTIONS
1
Main Cam
2
Pinch Roller Cam
Joint Gear
Fig. 2-14-A
Fig. 2-14-B
1
Main Loading Gear
Loading Arm T Unit
Loading Arm S Unit
Fig. 2-15-A
NOTE
1. When you install the Loading Arm S Unit, Loading Arm
T Unit and Main Loading Gear, align each marker.
(Refer to Fig. 2-15-B)
Main Loading Gear
Marker
Loading Arm T Unit
2-16: CLUTCH ASS'Y/RING SPRING/CLUTCH LEVER/
CLUTCH GEAR (Refer to Fig. 2-16-A)
Remove the Polyslider Washer 1.
1.
2. Remove the Clutch Ass'y and Ring Spring.
3. Remove the Clutch Lever.
4. Remove the Coupling Gear, Coupling Spring and
Clutch Gear.
Coupling Gear
Coupling Spring
Clutch Gear
B2-5
Marker
Loading Arm S Unit
Fig. 2-15-B
1
Clutch Ass'y
Ring Spring
Clutch Lever
Fig. 2-16-A