Disassembly Instructions; Removal Of Mechanical Parts And P.c. Boards - Memorex MVDT2002SM Service Manual

1. REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
1-1: BACK CABINET (Refer to Fig. 1-1)
1. Remove the 6 screws (1).
2. Remove the 2 screws (2).
3. Remove the Back Cabinet in the direction of arrow.
Front Cabinet
(1)
(1)
(1)
(1)
(2)
(2)
(1)
1-2: CRT PCB (Refer to Fig. 1-2)
CAUTION: BEFORE REMOVING THE ANODE CAP,
DISCHARGE ELECTRICITY BECAUSE IT
CONTAINS HIGH VOLTAGE.
BEFORE ATTEMPTING TO REMOVE OR
REPAIR ANY PCB, UNPLUG THE POWER
CORD FROM THE AC SOURCE.
1. Remove the Anode Cap.
(Refer to REMOVAL OF ANODE CAP)
2. Disconnect the following connectors:
(CP603B, CP803 and CP805).
3. Remove the CRT PCB in the direction of arrow.
Front Cabinet

DISASSEMBLY INSTRUCTIONS

(1)
Back Cabinet
Fig. 1-1
CRT PCB
Fig. 1-2
1-3: TV/DVD/VCR BLOCK (Refer to Fig. 1-3)
1. Remove the 2 screws (1).
2. Disconnect the following connectors:
(CP303, CP404 and CP1704).
3. Remove the TV/DVD/VCR Block in the direction of
arrow.
Front Cabinet
1-4: VCR DECK (Refer to Fig. 1-4)
NOTE
Do not remove the cable at the FE Head section. The FE
Head may be damaged if you remove the cable by force.
1. Remove the 2 screws (1).
2. Remove the VCR Top.
3. Move the Cassette Holder Ass'y to the back side.
4. Remove the 3 screws (2).
5. Remove the 2 screws (3).
6. Remove the Deck Shield Cover.
7. Remove the screw (4).
8. Remove the FE Head.
9. Disconnect the following connectors:
(CP101, CP4501 and CP4502).
10. Remove the VCR Deck in the direction of arrow.
(3)
Deck Shield Cover
(4)
FE Head
(1)
(1)
VCR Top
B1-1
(1)
(1)
TV/DVD/VCR Block
Fig. 1-3
(2)
(2)
(3)
(2)
VCR Deck
Bottom Plate
Fig. 1-4