NOTE
1. In case of the T Brake Band installation, install correctly
as Fig. 2-7-B.
[OK]
T Brake Band
[NG]
T Brake Band
2-8: S REEL/T REEL/IDLER ARM ASS'Y/IDLER GEAR
(Refer to Fig. 2-8-A)
1.
Remove the S Reel and T Reel.
Remove the 2 Polyslider Washers 1.
2.
3.
Remove the Idler Arm Ass'y and Idler Gear.
NOTE
1.
Take care not to damage the gears of the S Reel and T
Reel.
2.
The Polyslider Washer may remain on the back of the
reel.
3.
Take care not to damage the shaft.
4.
Do not touch section "A" of S Reel and T Reel. (Use
gloves.) (Refer to Fig. 2-8-A) Touching may leave stains
on section "A"
5.
When you install the reel, clean the shaft and grease it
(FG-84M) . (If you do not grease, noise may be heard in
FF/REW mode.)
6.
After installing the reel, adjust the height of the reel.
(Refer to MECHANICAL ADJUSTMENT)
Idler Gear
(B)
S Reel
(A)
1
DISASSEMBLY INSTRUCTIONS
T Brake Arm
T Brake Arm
Fig. 2-7-B
Idler Arm Ass'y
T Reel
(A)
1
Fig. 2-8-A
NOTE
1.
In case of the S Reel and T Reel installation, check if the
correct parts are installed. (Refer to Fig. 2-8-B)
2.
In case of the Idler Arm Ass'y installation, install correctly
as Fig. 2-8-C. And also set it so that the section "B" of
Fig. 2-8-A is placed under the Main Chassis tab.
[OK]
Clutch Gear
[NG]
Clutch Gear
2-9: CASSETTE OPENER/PINCH ROLLER BLOCK/
P5 ARM ASS'Y (Refer to Fig. 2-9-A)
Unlock the support 1 and remove the Cassette
1.
Opener.
2.
Remove the Pinch Roller Block and P5 Arm Ass'y.
NOTE
Do not touch the Pinch Roller. (Use gloves.)
1.
2.
In case of the Pinch Roller Block and the Pinch Roller
Cam installation, install correctly as Fig. 2-9-B.
Pinch Roller Block
P5 Arm Ass'y
B2-3
Big Hole
Small Hole
(S Reel)
(T Reel)
Idler Arm Ass'y
Idler Arm Ass'y
Cassette Opener
1
Pinch Roller Block
P5 Arm Ass'y
Main Chassis
Can be seen the hole of
the Pinch Roller Cam.
Can be seen the hole of the
Main Cam.
Fig. 2-8-B
Fig. 2-8-C
Fig. 2-9-A
Fig. 2-9-B