Multimeter Safety - Fluke 87 TRUE RMS MULTIMETER User Manual

87
Users Manual
A Touch Hold mode that allows you to keep your
eyes fixed on the probes when taking measurements
in difficult or hazardous circumstances, then read the
display when it is convenient and safe.
A display back-light that makes the meter useable in
dark areas.
A 4 ½-digit display mode for a ten times increase in
resolution.
A Capacitance mode that measures capacitors from
0.01 nF to 5 F.
After unpacking the meter, if you notice that the meter is
damaged or something is missing, contact the place of
purchase immediately. Save the shipping container and
packing material in case you have to reship the meter.

Multimeter Safety

Before using the meter, read the following safety
information carefully. In this manual the word, "Warning,"
is reserved for conditions and actions that pose hazard(s)
to the user; the word, "Caution," is reserved for conditions
and actions that may damage your meter. The symbols
shown in Table 1 are used internationally to denote the
electrical functions and conditions indicated. If the meter is
not used as described in this manual, the safety features
of the meter might be impaired.
2
Avoid working alone.
Do not allow the meter to be used if it is damaged, or
it's safety is impaired.
Inspect the test leads for damaged insulation or
exposed metal. Check test lead continuity. Damaged
leads should be replaced.
Be sure the meter is in good operating condition.
During a continuity test, a meter reading that goes
from overload (OL) to 0 generally means the meter is
working properly.
Select the proper function and range for your
measurement.
In order to maintain the safety protection of this
meter, use only parts listed in the Service Manual.
Refer to Table 7 for the Service Manual part number.
CAT III: For making measurements on equipment in
fixed installations (industrial).
Warning
To avoid electrical shock, use caution when
working above 60V dc or 30V ac rms. Such
voltages pose a shock hazard.