Holster And Flex-Stand; Applications - Fluke 87 TRUE RMS MULTIMETER User Manual

28
MIN Minimum Value in MIN MAX Recording
Mode
The value displayed is the minimum reading taken
since the MIN MAX Recording mode was entered.
29
AVG Average Value in MIN MAX Recording
Mode
The value displayed is the true average of all
readings taken since the MIN MAX Recording mode
was entered.
H
30
Hold
The meter is operating in a Display Hold mode. See
item 10 for Display Holds.
31 The following annunciators indicate the unit of the
value displayed:
AC Alternating current or voltage
DC Direct current or voltage
V Volts
mV Millivolts (1 x 10
A Ampere (amps). Current
mA Milliampere (1 x 10
uA Microampere (1 x 10
-3
volts)
-3
amps)
-6
amps)
nS Nanosiemens (1 x 10
(1/ )
% Percent Annunciator (for duty cycle readings
only)
Ohms. Resistance
3
k Kilohm (1 x 10
M Megohm (1 x 10
Hz Hertz (1 cycle/sec). Frequency
kHz Kilohertz (1 x 10
F Microfarads (1 x 10
nF Nanofarads (1 x 10
32
Not Used
Duty Not Used

Holster and Flex-Stand

The meter comes with a snap-on holster that absorbs
shocks and protects the meter from rough handling. The
holster is equipped with a Flex-Stand. Some uses of the
holster with Flex-Stand are shown in Figure 2.

Applications

This section discusses some common applications for
your meter, and alerts you to some considerations to keep
in mind when taking measurements.
Applications
-9
siemens). Conductance
ohms). Resistance
6
ohms). Resistance
3
cycles/sec). Frequency
-6
Farads). Capacitance
-9
Farads). Capacitance
17