Table of Contents
Advertisement
Spread Spectrum
This item allows you to set the CPU Host/PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
Host/PCI clock at Next boot is
This item allows you to select CPU/PCI frequency step by step increasing.
The choice are: 100MHz∼200MHz
DRAM Clock at Next Boot is
This item allows you to set the DRAM clock synchronous as CPU Host Clock or
Asynchronous as Host clock 100MHz, 133MHz, 166MHz to approach your DDR SDRAM
specification.
CPU Vcore Select
This item allows you to select Vcore of the CPU. The choice are: +1.650V∼+1.850V.
Vcc1.5 Select
This item allows you to select 1.5V of the AGP VGA card. The choice are: Default, 1.5V,
1.6V.
VDIMM Select
This item allows you to select 2.5V of the DDR Module. The choice are: 2.5V~2.8V
Flash Part Write Protect
This item allow you protect your BIOS chip from Virus destroy data. When Flash BIOS
you have Disabled this item.
3-12 Load Standard/Optimized Defaults
Load Standard Defaults
When you press <Enter> on this item, you get confirmation dialog box with a message
similar to:
Load Standard Defaults (Y/N)? N
Pressing <Y> loads the BIOS default values for the most stable, minimal-performance
system operations.
Load Optimized Defaults
When you press <Enter> on this item, you get a confirmation dialog box with a message
similar to:
Load Optimized Defaults (Y/N)? N
Pressing <Y> loads the default values that are factory settings for optimal performance
system operations.
3-13 Set Supervisor/User Password
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
User password:
Can enter and change the options of the setup menus.
Can only enter but do not have the right to change the options of
the setup menus. When you select this function, the following
39
Advertisement
Table of Contents
