Table of Contents
Advertisement
(2) Keyboard Power On function Enabled/Disabled: JP1
When setting Enabled you can using keyboard by key in password to power on system.
(3) USB Power On function Enabled/Disabled: JP4
When setting JP1 2-3 closed Enabled Keyboard Power On Function, you can setting
JP4 2-3 closed enabled USB Power On Function for using USB device to power on
system.
(4) ATA100/RAID Mode Selector: JP13 (Only for I402R)
When JP13 1-2 closed the IDE3 & IDE4 are setting in ATA100 Mode supports Ultra
DMA 100MB/sec transfer rate.
When JP13 2-3 closed the IDE3 & IDE4 are setting in RAID Mode supports RAID 0
(striping) to increase hard drive performance or RAID 1 (mirroring) to protect hard
drive data, for more detail information please refer CD-PACK in
X:\MANUAL\PROMISE.DOC
Note:
If you only install hard drive in IDE3 and IDE4 and the JP13 setting 2-3 closed
then this driver must install IDE RAID 0 or IDE RAID 1 Mode by Fast Build
Utility, please press <Ctrl-F> to enter setup Main Menu and choose "Auto
Setup" to setup your hard drive.
1
3
JP1
1-2 closed K/B Power ON Disable
(Default)
1
3
JP4
1-2 closed
USB Power ON Disable
(Default)
USB Power On function Setting
8
JP1
2-3 closed K/B Power ON Enabled
Keyboard Power On Setting
JP4
2-3 closed
1
3
1
3
USB Power ON Enabled
Advertisement
Table of Contents
