Load Standard/Optimized Defaults - JETWAY ALIOTH User Manual

Spread Spectrum
This item allows you to set the CPU Host/PCI clock and Spread Spectrum.
The settings are: Enabled, Disabled.
Host/PCI Clock at Next Boot
This item allows you to select CPU frequency step by step increasing.
The choice are: 100MHz∼200MHz
DRAM Clock at Next Boot is
This item allows you select the DRAM Clock same as Host clock, or can add 33MHz when
100MHz/133MHz. The setting are 100MHz, 133MHz, 166MHz.
PCI Clock Ratio
This item allows you to set PCI Clock Ratio. The choice are: Host/3, Host/4, Host/5, Host/6.
CPU Vcore Select
This item allows you select CPU Vcore Voltage by increase 0.025V step by step from 1.6V to
1.8V the Default setting is Default (CPU manufacturer Default setting).
Vcc1.5 Select
This item allows you to select 1.5V of the AGP VGA card. The choice are: Default, 1.5V,
1.6V.
VDIMM Select
This item allows you to select DRAM Voltage. The choice are: 2.5V/2.6V/2.7V/2.8V.
Flash Part Write Protect
This item allows you protect your BIOS chip from Virus destroy data. When Flash BIOS you
have Disabled this item.

3-12 Load Standard/Optimized Defaults

Load Standard Defaults
When you press <Enter> on this item, you get confirmation dialog box with a message similar
to:
Load Standard Defaults (Y/N)? N
Pressing <Y> loads the BIOS default values for the most stable, minimal-performance system
operations.
Load Optimized Defaults
When you press <Enter> on this item, you get a confirmation dialog box with a message
similar to:
Load Optimized Defaults (Y/N)? N
Pressing <Y> loads the default values that are factory settings for optimal performance system
operations.
3-13 Set Supervisor/User Password
You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
User password:
Can enter and change the options of the setup menus.
Can only enter but do not have the right to change the options of the
33