Expansion Card - JETWAY ALIOTH User Manual

This motherboard provides
sites for memory expansion available from minimum memory size of 64MB to maximum
memory size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank
Bank 0, 1 (DDR1)
Bank 2, 3 (DDR2)
Bank 3, 2 (DDR3)
Total
For Specification Limited!
DDR2 and DDR3 only can use one double size DDR either DDR2 for DDR3, it can not accept 2
pcs double size or 1 pcs double size 1 pcs single size DDR Memory together.
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can refer to
figure 2-4 to see what a 184-Pin DDR200/DDR266/DDR333 DDR SDRAM module looks like.
NOTE! When you install DIMM module fully into the DIMM socket the eject tab should be
locked into the DIMM module very firmly and fit into its indention on both sides.
WARNING! For the DDR SDRAM CLOCK is set at 133MHz, use only DDR266-compliant DDR
Modules. When this motherboard operate at 133Mhz, most system will not even
boot if non-compliant modules are used because of the strict timing issues, if your
SDR Modules are not DDR266-compliant, set the DDR SDRAM clock to 100MHz
to ensure system stability.
2-5 Expansion Cards
WARNING! Turn off your power when adding or removing expansion cards or other system
components. Failure to do so may cause severe damage to both your motherboard
and expansion cards.
2-5-1 Procedure For Expansion Card Installation
three 184-pin DUAL INLINE MEMORY MODULES (DIMM)
184-Pin DIMM
DDR200/DDR266/DDR333
DDR SDRAM Module
DDR200/DDR266/DDR333
DDR SDRAM Module
DDR200/DDR266/DDR333
DDR SDRAM Module
System Memory (Max. 2.0GB)
9
Total Memory
X1
64MB∼1.0GB
X1
64MB∼1.0GB
X1
64MB∼1.0GB
2
64MB∼2.0GB
Figure 2-4