JETWAY ALIOTH User Manual page 16

(7) Parallel Port Connector (25-pin female): PARALLEL
Parallel Port connector is a 25-pin D-Subminiature Receptacle connector. The On-board
Parallel Port can be disabled through the BIOS SETUP.
"INTEGRATED PERIPHERALS SETUP" section for more detail information.
(8) Audio and Game Connector : GAME
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC and a 15-pin
D-Subminiature Receptacle Connector for joystick/MIDI Device.
Line-out :
Line-in :
MIC :
Game/MIDI :
(9) VGA Connector (15-pin D-Sub) Connector: VGA (for Alioth GE only)
VGA is the 15-pin D-Subminiature female connector for display monitor.
(10) Serial Port COM1/COM2: COM1/COM2A (COM2A only for Alioth PE)
COM1/COM2A is the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS
SETUP" section for more detail information.
(11) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to the floppy drives.
(12) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
Audio output to speaker
Audio input to sound chip
Microphone Connector
For joystick or MIDI Device
PS/2
MOUSE
LAN
PS/2
Keyboard
USB COM1 VGA/COM2A
PRINT GAME/MIDI PORT
FDD
Pin 1
Floppy Drive Connector
13
Please refer to Chapter 3
MIC
LINE-IN
LINE-OUT