JETWAY 848PDCR2A User Manual page 16

(6) Audio Line-In, Lin-Out, MIC Connector : CN1
This Connector are 3 phone Jack for LINE-OUT, LINE-IN, MIC
Line-out :
Line-in :
MIC :
(7) Serial Port COM1: COM1
COM1 is the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED
PERIPHERALS SETUP" section for more detail information.
(8) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to the floppy drives.
(9) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting
the single plug end to motherboard, connect the two plugs at other end to your hard
disk(s). If you install two hard disks, you must configure the second drive to Slave
mode by setting its jumpers accordingly. Please refer to the documentation of your
hard disk for the jumper settings.
Audio output to speaker
Audio input to sound chip
Microphone Connector
PS/2
Keyboard
Pin 1
PS/2
LAN
Mouse
COM1 USB2 USB1
FDD
Floppy Drive Connector
13
MIC
LINE-IN
LINE-OUT