Table of Contents
Advertisement
2. The Hawking Wireless Utility will
automatically pop up. You will be
asked to enable your WLAN card.
When a NOTICE comes up, select "OK".
3. Go to the APPLE icon on the top left
corner of your desktop, select System
Preferences Network Settings.
If this is your first time using the
Hawking Wireless Adapter on your
computer, you will need to enable the
device before using the Wireless Utility.
In the System Preferences page, locate
the NETWORK icon and double click it
to access the control panel.
4. The new USB wireless adapter will
automatically be detected. Click "OK" to
continue.
5. Click "APPLY NOW" to confirm the
selection.
6. From your Network Preferences, select
'Ethernet Adapter (en...)', then click
'Apply.' Then skip the section below
and go to step 4.
If you are planning to use a static IP and
manually enter an IP address, please go
to section 3.4 Configure IP Manually
vs. Automatic (DHCP)
53
Advertisement
Table of Contents
