Hawking HAWNU1 User Manual page 32

When you use 'EAP-FAST' as authentication type, the protocol setting
is always 'Generic Token Card' and cannot be modified. You also need
to select 'Soft Token' or 'Static Password' as password in 'ID \
Password' setting.
'EAP Fast' authentication type also have a sub-menu to set EAP
fast-specific parameters:
If you need to use protected authentication credential, check 'Use
protected authentication credential' box, and click 'Import' to load
credential file; to remove a loaded credential file, click 'Remove'.
Session You can enable or disable session resumption here. If you are unsure
Resumption about enabling session resumption or not, please ask your 802.1x
authentication administrator.
ID \ Password Input 802.1x username (ID) and password and other information if it is
tab required here. Click 'Show Password' to show the actual character from
your password.
Client Use this tab to select a local certificate from dropdown menu. If the
Certification tab access point you wish to connect requires a specific client certificate,
the certificate must be installed on your computer, then you can select
the certificate from your computer.
Server Use this tab to use server-based certification. Please select a CA
Certification tab (Certificate Authority) from dropdown menu. If intermediate
certificates are allowed, please select 'Allow intermediate certificates'.
Also, if you need to specify CA server's name, you can specify it in
'Server name' field. You can select 'Server name must match', so the
CA server's name must be the same with the value you set in 'Server
name' field; If only the domain name part of full server name must the
same with the value you set in 'Server name' field, select 'Domain
name must end in specified name'.
After you complete all information related to the access point, click 'OK' to save the profile,
or click 'cancel' to cancel adding a new profile.
If the profile is created, you will see the information in the Profile List.
25