Table of Contents
Advertisement
You can click 'PBC' button few more times to try again. When an access point is
connected, you can click 'Disconnect' to disconnect your wireless network card from a
connected access point, or select another WPS-enabled wireless access point, then click
'Connect' to establish connection to selected access point, if there are more than one
WPS-enabled access point found. You can also click 'Rotate' button, and next access
point on the list will be selected to establish connection.
If you want to delete a found access point from the list, select it and click 'Delete' button.
WPS Setup - PIN
If the wireless access point you wish to connect supports PIN, please follow the following
instructions to establish connection to it:
1. Right-click the Hawking configuration utility icon located at lower-right corner of
computer desktop and then click 'Launch Config Utility'.
2. Click 'WPS Configuration' menu, and the following settings will appear.
37
Advertisement
Table of Contents
