Appendix; Connector And Cable Specifications - Cisco 675E Hardware Installation Manual

Connector and Cable Specifications

This appendix describes the cable connector that is used to connect the Cisco
Redundant Power System (RPS) 675 to a supported device. The cable
(CAB-RPS-1614=) is a 48-inch (1.2-meter) cable with a 16-pin connector on one
end and a 14-pin connector on the other end.
connectors, and
The connector is keyed to insert into the receptacle only in its correct orientation.
Note
Figure B-1
78-15201-04
Table B-1 contains the pinout information.
14-Pin Connector Pinouts
Top of Connector (Logo Side)
14 13 12 11 10
1 2 3 4 5
Cisco RPS 675 Redundant Power System Hardware Installation Guide
A P P E N D I X
Figure B-1
9 8
6 7
B
and Figure B-2 show the
B-1