Mounting The Rps In A Rack; Connecting The Rps 675 - Cisco 675E Hardware Installation Manual

Connecting the RPS 675

Mounting the RPS in a Rack

Figure 2-5 Mounting the RPS in a Rack
STA ND BY/
ACT IVE
OU TPU
T PW R
TEM P DC OU TP
1
UT
FAN
2
3
STA ND BY/
ACT IVE 4
1
1 Phillips machine screws
Connecting the RPS 675
Caution
Note
Cisco RPS 675 Redundant Power System Hardware Installation Guide
2-14
After the brackets are attached to the RPS, use the four supplied number-12
Phillips machine screws to securely attach the brackets to the rack, as shown in
Figure 2-5.
5
6
1
Make sure that the RPS is either in standby mode or that the RPS AC power is
disconnected before you connect the RPS to a switch. This precaution is necessary
because when you connect the RPS to the AC power, the RPS automatically
becomes active.
Do not use different power sources to power up the RPS and the connected device.
If you connect to separate AC power sources, reset conditions might occur.
C is co R
P S 30 0
Chapter 2 Installation
78-15201-04