Audio Setup; Speaker Setting - Kenwood KDC-MP632U - USB/AAC/WMA/MP3/CD Receiver With External Media Control Instruction Manual

General features
Audio Setup
Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
- Adjust the volume of Rear channel by <Audio
Control> (page 12).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the Auxiliary
input sources listed below.
- Internal auxiliary input (KDC-MP632U only)
- Option CA-C1
AXI
CA-C2AX (KDC-X590 only)
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
Front High Pass
IIHPF II
Filter*1,3
Rear High Pass Filter*1,3IIHPR II
Low Pass Filter*l,2,3 11 LPFII
Subwoofer Phase*l,2,3,4 IIPHAS II
Volume offset
IIV-OFF II
Loudness
IILOUD '
!
Dual Zone System*l 112Z0N"
~
~
Through/40*5/60*5/80/1 00/
120/150/180/220*5 Hz
Through/40*5/60*5/80/100/
120/150/180/220*5 Hz
50*5/60/80/100*5/120/
Through Hz
-8-±0
OFF/ON
OFF/ON
1
Enter Standby
Press the [SRC] button.
Select the IISTANDBY
II
display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting
alternates between the settings shown in the
table below.
4
Exit Speaker Setting mode
Press the [VOL] knob.
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
• *1
Function of KDC-X590/MP632U.
• *2
You can control this item when <Switching preout>
(page 30) is set to "SWPRE SW". (KDC-MP632U only)
• *2
You can control this item when <Subwoofer
Output> (page 15) is set to "SW ON".
• *3
You can control this item when "2Z0N" of <Audio
Setup> (page 14) is set to "OFF".
• *4
You can control this item when Low Pass Filter is not
set to Through.
• *5
KDC-X590 only
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 30).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
14 I
English
OFF
For 5
&
4in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
liSP OFF '
!
liSP 5/4 11
liSP 6*9/6 11
"SP OEM"